Upgrade to Pro — share decks privately, control downloads, hide ads and more …

Lithium-ion Battery HILS: A Cell Emulator That ...

Lithium-ion Battery HILS: A Cell Emulator That Behaves Like a Real Battery

his presentation introduces the overview, technical characteristics, and development status of the Lithium-ion Battery HILS (cell emulator) currently under development by Marutsuelec Co., Ltd. Testing with real batteries during BMS (Battery Management System) or charger development presents several challenges: charge and discharge cycles take hours, reproducing consistent states (SOC, temperature, and aging) is difficult, and edge-case tests such as over-discharge and overcharge pose safety risks. This instrument computes a battery SPICE model in real time on an MCU and outputs the resulting voltage, making it appear to the connected device just like a real battery. Key Features and ApplicationsHigh Model Accuracy and Fast Transient Response: Matches the original SPICE model (ngspice) within a voltage difference of $\le 1.2\text{ mV}$ and a discharge-time difference of $\le 0.2\%$. With a control loop running at 200,000 times per second, it settles to within $\pm 5\text{ mV}$ of the model voltage in approximately $150\ \mu\text{s}$ during a $0 \to 5\text{ A}$ load step, while also absorbing charging current via an internal brake resistor (regen clamp). Four Cell-Isolated Channels: Provides four isolated channels ($0\text{–}5\text{ V} / \pm 5\text{ A}$) that can be stacked in series up to a 4S pack (up to $\sim 17\text{ V}$) without interference, while allowing individual capacity and initial SOC settings to reproduce cell-to-cell variation. Faster and Safer Evaluation: Supports BMS SOC estimation checks, over-discharge and over-current protection tests, and charger evaluation. A time-acceleration mode (TSCALE 1–3600) allows hours-long discharge tests to be verified in a fraction of the time. Circuit design (Rev.A for cell channel and master boards), SPICE simulations, and model firmware verification against the original model have been completed, with prototype preparation and testing next.

Tsuyoshi Horigome

November 19, 2026

Transcript

10 slides
  1. Lithium-ion Battery HILS A cell emulator that behaves like a

    real battery Marutsuelec Co., Ltd. | Rev.A design stage (in development)
  2. Testing with real batteries is hard In development Developing a

    BMS or a charger means testing with real batteries. Charge and discharge take hours TIME Half a day per test, days when repeated BMS / Charger Device under development Hard to reproduce the same state STATE SOC, temperature and aging change the result Edge-case tests are dangerous RISK Marutsuelec Co., Ltd. | Battery HILS overview Over-discharge and overcharge are risky on real cells 2
  3. Replace the battery with a source that computes one Battery

    HILS In development + BMS / Charger Device under test Compute model → output voltage − An instrument that computes a battery model in real time and outputs its voltage. To the connected device, it looks just like a real battery. The device sees a “real battery” Marutsuelec Co., Ltd. | Battery HILS overview 3
  4. Built on a battery SPICE model In development Bee Technologies

    “Li-Ion Battery Simplified SPICE Behavioral Model” + terminal OCV Open-circuit voltage Internal R (Rs) varies with SOC instant voltage drop Polarization 1 Polarization 2 τ ≈ 28 s τ ≈ 260 s Inputs Open-circuit voltage versus SOC, internal resistance and two polarization terms describe the cell voltage. Rate-dependent capacity loss is included. Time constants are for a 1.4 Ah single cell. Marutsuelec Co., Ltd. | Battery HILS overview Capacity C [Ah] Initial SOC [%] Cells in series (1 channel = 1 cell) 4
  5. The MCU model matches the original SPICE model SPICE 0.2C

    SPICE 0.5C SPICE 1C MCU 0.2C MCU 0.5C In development MCU 1C Voltage difference 4.3 ≤ 1.2 mV 4.1 Terminal voltage [V] 3.9 Discharge-time difference 3.7 ≤ 0.2 % 3.5 3.3 3.1 Grey: original SPICE model (ngspice). Green: model ported to the MCU. The two curves almost overlap. Discharge time: 0.2C 297 min, 0.5C 118 min, 1C 58 min. 2.9 2.7 0 60 120 180 240 300 Time [min] (1.4 Ah cell, constant-current discharge) Marutsuelec Co., Ltd. | Battery HILS overview 5
  6. Four channels, isolated per cell In development Channel 1 0–5

    V / ±5 A Channel 2 Cell 1 Cell 2 0–5 V / ±5 A Channel 3 Cell 3 0–5 V / ±5 A Cell 4 Channel 4 0–5 V / ±5 A 4S pack in series (up to ~17 V) Capacity and SOC can be set per cell to reproduce cell-to-cell variation. The channels are isolated, so they do not interfere when stacked in series. Marutsuelec Co., Ltd. | Battery HILS overview 6
  7. Responds to load steps just like a battery Battery model

    (ideal) In development HILS output (SPICE) Control loop 4.25 200,000 / s Terminal voltage [V] 4.15 Settles to model voltage (±5 mV) 4.05 ≈ 150 µs 3.95 Absorbs charger current too 3.85 Returned energy is dissipated in an internal brake resistor (regen clamp) 3.75 -50 0 50 100 150 200 250 300 350 400 Time from 0→5 A load step [µs] (1.4 Ah equivalent, Rs' 32 mΩ) The ringing right after the step comes mainly from wiring inductance and DUT input capacitance (an ideal battery on the same wiring shows it too). Marutsuelec Co., Ltd. | Battery HILS overview 7
  8. Applications In development SOC PROT CHG BMS SOC estimation Protection

    checks Charger evaluation Reproduce the SOC–voltage relationship under identical conditions every time Over-discharge and over-current, safely, without a real cell at risk Absorbs charge current and reproduces the rising cell voltage Time-acceleration mode (TSCALE 1–3600) Fast-forward model time to check hours-long discharge tests in a fraction of the time. Marutsuelec Co., Ltd. | Battery HILS overview 8
  9. Development status In development ✓ ✓ ✓ Next Circuit design

    (Rev.A) SPICE simulation Model firmware Prototype & test Cell channel and master boards Response, regen, ripple Verified against the original model Next step We have completed the first-revision circuit design, simulations and model firmware, and are now preparing the prototype. Specifications are development targets; figures are simulation results. Marutsuelec Co., Ltd. | Battery HILS overview 9
  10. Testing battery-powered devices, faster and safer. Talk to Marutsuelec Co.,

    Ltd. Battery model: Bee Technologies Li-Ion Battery Simplified SPICE Behavioral Model Video narration: Kokoro-82M text-to-speech (Apache-2.0)

More Decks by Tsuyoshi Horigome

Other Decks in Technology